Panasonic PAW280MAH2 Instructions d'exploitation télécharger pdf (Page 56)

Electrical Wiring

4. Place the wire-end sleeve into the socket on the connector and replace and tighten the re-

moved terminal screw using a at-blade screwdriver.

Special washer

Screw and special washer

Screw

Terminal plate

Wire

Wire-end sleeve

Wire

Wire-end sleeve

Shielded wire

1. Remove cable sheath not to scratch braided shield.

2. Unbraid the braided shield carefully and twist the unbraided shield wires tightly together.

Insulate the shield wires by covering them with an insulation tube or wrapping insulation tape

around wire.

Insulation tape Shield mesh

3. Remove insulation of signal wire.

Insulation tape Shield mesh

8 mm

4. Attach wire-end sleeves to the signal wires and the shield wires insulated in step 2 using a

crimping tool.

Wire-end sleeve

5. Connect the shield for the inter-unit control wiring to ground.

1 2 ... 51 52 53 54 55 56 57 58 59 60 61 ... 73 74

Pas de commentaire

Panasonic PAW280MAH2 Instructions d'exploitation Page 56