Panasonic EP1060G2 Instructions d'exploitation télécharger pdf (Page 7)

• It is possible to carry out leg massage at the same time as upper body massage.

• If your calves are not in the correct position in the legrest, please adjust your legs so that they are.

1. Press the button

• The programmed operation and leg massage button will flash.

2. Press the Leg Massage button

• The massage will start.

• The intensity of the massage will be displayed.

• It is possible to adjust the reclining angle during the massage.

Air will be released from the legrest while the Reclining Button

is pressed. Adjust the position of your legs during this time.

3. Adjusting Massage Intensity

• Leg massage intensity can be adjusted in 2 stages (EP1060).

• Leg massage intensity can be adjusted in 2 stages (EP1260).

4. Leg Massage Auto Stop

• A timer will automatically stop the unit approximately 15 minutes (15–17 minutes) after the massage started.

• If you want to start another massage, please press the button.

5. STOPPING MANUAL OPERATION

Press the button to stop the leg massage.

• It will take some time before all the air escapes from the leg massage unit.

(Air will continue to escape even after the button has been pressed.)

LEG MASSAGE IN MANUAL OPERATION

gentle strong

leg massage

gentle strong

leg massage

gentle strong

leg massage

gentle strong

leg massage

gentle strong

leg massage

Gentle Strong Off

Press

Press Press Press

Note

Integrated Timer to Prevent Overuse

• An integrated timer prevents overuse of the unit.

• When using manual operation, the timer automatically stops operation after 15 minutes (15–17 minutes).

* If you want to continue to use the unit, please wait at least 10 minutes between massages to allow your

body to rest.

gentle strong

leg massage

gentle strong

leg massage

gentle strong

leg massage

Strong Gentle Off

Press Press Press

4. Adjusting Manual Massage Settings

Adjusting the Vertical Position of the Massage Heads

• The massage heads will move a little each time the button is

pressed. If you hold down the button, the massage heads will

continue to move until you release the button. When the

massage heads reach their limit you will hear a “peep, peep,

peep” sound.

Adjusting the Width between Massage Heads

• Vibration, Tap, Shiatsu Whole Back Roll, and Regional Roll

can be adjusted in 5-stages while Swedish can be adjusted in

3-stages.

• As Swedish covers the entire width of the back, it is not

possible to adjust width settings.

• The massage heads will move a little each time the button is

pressed. If you hold down the button, the massage heads will

continue to move until you release the button.

• When the massage heads reach their limit you will hear a

“peep, peep, peep” sound.

Adjusting Massage Intensity

• Massage intensity can be adjusted in 3 stages.

• When the massage heads reach their limit you will hear a

“peep, peep, peep” sound.

• As Roll or combining Roll with other massages sometimes

produces an especially strong massage, adjustment is limited

to medium or weak.

Example 2 Changing to a massage type outside the category.

(Changing to Tap B when Knead is selected.)

• When Knead is combined with Tap B, deselecting Knead will leave only Tap.

roll

manual operation

whole back

regional

tap Avibration tap B

swedishshiatsu knead

roll

manual operation

whole back

regional

tap Avibration tap B

swedishshiatsu knead

roll

manual operation

whole back

regional

tap Avibration tap B

swedishshiatsu knead

Press

positionposition

Raising the massage heads Lowering the massage heads

Press

positionposition

Increasing the width Decreasing the width

Press

intensityintensity

Increasing massage intensity Decreasing massage intensity

Press

Roll, Roll + (Shiatsu, Tap B, Tap A, Vibration) Combination..................................Weak/Medium

Roll + (Knead, Swedish Combination) ...................................................................Weak

• For Tap B, Swedish, and Vibration, unless the massage heads are actually touching the body, you may not

feel the movement.

5. Auto Stop in Manual Operation

• A timer will automatically stop the unit approximately 15 minutes (15–17 minutes) after the massage started.

(This is to prevent overuse in the interests of safety.)

• The massage heads will move to the retracted position and stop.

• The ON/OFF lamp will flash until the heads have stopped moving.

• If you want to start another massage, please press the button.

• Please wait at least 10 minutes between massages to allow your body to rest.

6. Stopping Manual Operation

Press the button to stop manual operation.

• The ON/OFF lamp will continue to flash until the massage heads have returned to the retracted position.

1 2 3 4 5 6 7 8 9 10 11 12 13 14

Commentaires sur ces manuels

Pas de commentaire

Panasonic EP1060G2 Instructions d'exploitation Page 7

Commentaires sur ces manuels

Produits connexes et manuels pour Masseurs Panasonic EP1060G2