Panasonic EP1060G2 Instructions d'exploitation télécharger pdf (Page 3)

1. After Carrying Out Safety Checks, Turn the Unit On (See Page 36)

z Plug the power plug into the power socket.

x Turn the lock switch to the “open” position.

c Turn on the power switch on the back of the unit.

• Please always check for the following before using the unit.

- Check that there are no person, pets, or obstacles around the unit.

- Check that there are no rips in the fabric.

2. Press the button.

• When you press the button, the Programmed Operation and Leg Massage

Buttons will flash. If the cover of the controller is open, then the Manual Operation Selection Buttons will flash.

3. Select the Desired Program or the Desired Movement on the Manual Operation

Programmed Operation

• Ideal for people who feel tired all over.

• Ideal for people who want to operate the massage lounger simply.

z Select the required program.

x Press the Neck/Shoulder or Lower Back Buttons if you want to focus on a particular area.

c The chair will recline to the optimum angle for the massage. The massage will then begin

and continue until the end of the selected program is reached, at which time the massage

will automatically stop.

Manual Operation

• Used for selecting a particular massage movement or area to be massaged.

• Ideal for people who want to adjust movement and location during the course of a massage.

• Ideal for people who want just a little more on the shoulders at the end of their massage.

z Open the cover of the controller and select the massage required.

x The seat will automatically recline to the optimum massage position.

c Adjust the position and intensity of the massage rollers.

v Press the

button to complete the massage.

4. Adjust the Angle of the Backrest and Legrest (See Page 38)

•

Adjust the angle of the backrest and legrest to the most comfortable position.

• When retracting the backrest, as the massage heads must be retracted in the interests

of safety, there may be a slight delay before the backrest actually starts to retract.

Please continue to hold down the Reclining Button until the backrest is fully retracted.

5. Turn the Power Off to Finish the Massage

(See Page 45)

z Turn the power switch to the “off” position.

x Turn the lock switch the “lock” position.

c Unplug the power cord.

• Here you will find an overview of how to use the massage lounger. Please refer to the pages shown for further details.

HOW TO USE THE MASSAGE LOUNGER — INTRODUCTION

off

lock

lock switch

open

off

lock

lock switch

open

If excessive pressure is applied to the massage heads during upper body massage, in the interests

of safety the massage heads may stop moving. If this occurs, raise your body slightly before

restarting it. (This may happen more frequently for people who weigh 100kg or more.)

If the massage mechanism stops (or if all markings and buttons on the controller start to flash), turn

off the power switch, wait for approximately 10 seconds, and then turn the power switch on again.

Mat

Flat Surface

CAUTION

• Do not use the unit in areas with high humidity, such

as the bathroom, etc. as this can lead to electric

shock or other accidents.

• Place the unit on a totally flat surface. Failure to do

so may result in the seat tipping over.

WHERE TO USE THE UNIT

CAUTION

• Do not move the unit when someone is sitting in it as it may tip over.

MOVING THE SEAT

SETTING UP THE MASSAGE LOUNGER

30cm40cm 40cm

Wheels

Move it slowly

Hold the pipes

on both sides of

the legrest

Ensure there is Adequate Space for Reclining

• Ensure that there is approximately 40cm behind and at least

40cm in front of the unit.

Places to Avoid

• Do not use the unit in direct sunlight or in places where it will

be exposed to high temperatures, such as in front of a heater,

etc., as this can cause discoloration or hardening of the

synthetic leather.

Avoid Damaging Your Floor

• As there is the possibility that the unit may damage your floor,

we suggest that you place it on a mat, etc., which will also help

to reduce overall operating noise.

Moving the unit Using the Wheels

• Tilt the seat back by holding the pipes on both sides of the legrest and

allow the unit to roll on the wheels located at the back.

• Returning the massage heads to the retracted position and the seat

back to the upright position makes it easier to move the unit.

* As the unit may mark the floor when moved, please place a mat, etc.,

on the floor and move it slowly.

* Do not move the unit when someone is sitting in it.

Carrying the unit

• When carrying the unit, have one person hold the pipes on both sides

of the legrest and the other person lift the chair using the back cover

handles located on the back of the unit.

* As the unit may mark the floor if dropped, please ensure that you hold

the legrest and handles securely.

1 2 3 4 5 6 7 8 ... 13 14

Commentaires sur ces manuels

Pas de commentaire

Panasonic EP1060G2 Instructions d'exploitation Page 3

Commentaires sur ces manuels

Produits connexes et manuels pour Masseurs Panasonic EP1060G2