Panasonic EP1060G2 Instructions d'exploitation Page 4

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 14
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 3
37
CAUTION
• Slowly sit down after checking the position of the massage heads.
If you do not check the position of the massage heads, you may be injured or the unit may be damaged.
BEFORE SITTING DOWN
When the massage does not feel strong enough, lift up the
pillow and carry out the massage again.
ADJUSTING THE PILLOW
ADJUSTING THE SEAT
The massage heads are normally in the retracted position
(to the left and right at the lower part of the backrest).
Do not sit down if the massage heads are not in the
retracted position. Instead, push the button twice to
retract the massage heads to the proper position. (If the
button is pushed during the massage, then the
massage heads will not be retracted.)
Please do not sit on the controller as the reclining button
may be pressed causing the seat to automatically recline.
Sit Down Only When the Legrest is Lowered
If you sit on the unit when the legrest is raised, the verb
may itself means that the possibility exists, there is no
need to repeat this. It may fall over and you may be injured.
When the legrest is raised, press the button to lower the
legrest before sitting down.
reclining
Press
36
1. Check the Surrounding Area
z Check that there is nothing behind the unit.
x Check that there is enough room to recline the unit.
In the interests of safety, the unit may stop moving if it hits
something while reclining.
2. Check the Unit
z Lift up the pillow and the center cushion to check
that there are no rips in the fabric of the back
cushion, etc.
x Check that the power plug has not been damaged
or has pins or dust sticking to it.
AFTER CHECKING THE SURROUNDING AREA, TURN ON THE POWER
BEFORE USING THE UNIT
Do not leave
anything here.
40cm
40cm
Check
Main Cushion Fabric
3. Turn the Power On
z Plug the power plug into the power socket.
x Turn the lock switch to the “open” position.
c Turn on the power switch on the back of the unit.
When plugging the unit in, make sure that there are at least
10cm of slack in the power cord.
(Take care to ensure that the power cord is not caught by the
unit when it reclines.)
off
lock
lock switch
open
on
2
3
Vue de la page 3
1 2 3 4 5 6 7 8 9 ... 13 14

Commentaires sur ces manuels

Pas de commentaire