Panasonic WV-SW598 Guide d'installation télécharger pdf (Page 31)

Configure the network settings

Configuring the camera so that it can be accessed from a PC

The following are descriptions for when the camera with default settings is configured. If you are using firewall

software on your PC, the Setup Program may not be able to find any cameras on your network. Configure the

setting of the camera after temporarily invalidating the firewall software. Contact the network administrator or your

Internet service provider for information about configuring the settings of the network.

Insert the provided CD-ROM into the CD-ROM drive of your PC.

 • TheLicenseAgreementwillbedisplayed.ReadtheAgreementandchoose“Iaccepttheterminthelicense

agreement”, and click [OK].

 • Thelauncherwindowwillbedisplayed.Ifthelauncherwindowisnotdisplayed,doubleclickthe“CDLauncher.

exe” file on the CD-ROM.

Note:

•Referto“UsingtheCD-ROM”intheOperatingInstructionsontheprovidedCD-ROMforfurtherinformationabout

CDLauncher.

x Click the [Run] button next to [IP Setting Software].

[PanasonicIPSetting]screenwillbedisplayed.Clickthe[NetworkSettings]buttonafterselectingtheMACaddress/IP

address of the camera to be configured.

c Selectthecamerayouwanttoconfigure,andclick[AccessCamera].

Note:

•Whencamerasaredisplayedin[PanasonicIPSetting]screen,clickthecamerawithsameMACaddressasthe

MACaddressprintedonthecamerathatyouwanttoconfigure.

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 45 46

Pas de commentaire

Panasonic WV-SW598 Guide d'installation Page 31