Panasonic WV-SW598 Guide d'installation télécharger pdf (Page 21)

How to detach the housing base

Before attaching the camera to a custom-made mount bracket, detach the housing base and attachment pipe from the

camera so that installation and connections can be performed.

Step 1

Remove the fixing screws (3 pcs.*) that are securing the

housing base and the camera.

The removed screws will be required when attaching the

camera to the housing base. Use caution not to lose these

screws.

* Special screw (Fixing screw): These screws are hexagon

screws. Use an M5 hexagon wrench.

Fixing screws (3 pcs.)

Housing base

Camera

Protection Cover

Note:

 • If the front and rear sunshields (accessory) are

attached to the camera, detach them by performing

steps 5 - 7 of “Installation” in the reverse order.

(☞ Pages 24 and 25)

Protection Cover

IMPORTANT:

 • Remove the Protection Cover from the camera after

the installation is complete.

Step 2

To separate the housing base from the camera, turn the

housing base to the direction of the arrow as illustrated.

(Refer to the illustration in Step 1)

Step 3

Remove the attachment pipe from the upper base by

loosening 4 screws.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 45 46

Pas de commentaire

Panasonic WV-SW598 Guide d'installation Page 21