24
Setting/Changing hard disk mode after
resetting error
It is impossible to change or set up the hard disk mode
when the ERROR indicator and one of HDD access
indicators is lit red or is blinking. To set or change the
mode, repair the system so the indicators go out.
Refer to Troubleshooting of this manual and the operat-
ing instructions of the digital disk recorder for details.
Important:
• When an HDD indicator is lit or blinking red, the
HDD is faulty and should be replaced performing
the following steps.
• When less than three hard disks are mounted or the
mounted positions are wrong in RAID5, the HDD
indicators will blink red and be lit red. Add hard
disk(s) or correct the positions and then set up the
extension unit again.
• When the ERROR indicator is lit red and all HDD
access indicators are lit red and orange, it is a sys-
tem error. Consult your dealer.
1 SAFETY MODE ON
Select ON for HDD Safety Mode on the SETUP MENU
and press the SET button.
→ The recorder will restart and the HDD SAFETY
MODE window will be displayed.
2 Replacement of faulty HDD
• Confirm that the HDD POWER indicator on the front
panel of the extension unit has gone out.
• Replace the faulty hard disk referring to
■ Replacing/Mounting HDD.
• Go to the next step below after finishing the con-
nection of the front cover harness with the unit while
the switches and buttons remain operable (step 11
of ■ Replacing/Mounting HDD).
3 Initialization
1 Set the MODE switch to SINGLE.
2 While holding down the RECOVER button, press the
RESET button.
3 While holding down the RECOVER button, release
the RESET button about 1 second later.
4 Release the RECOVER button after the HDD
POWER indicator turns on.
Commentaires sur ces manuels