Panasonic EP1060 Manuel d'utilisateur télécharger pdf (Page 27)

Problem Cause and Remedy

Even though I press the reclining button

nothing appears to happen.

When retracting the backrest, in the interests of

safety, the massage heads move to the retracted

position before the backrest starts to retract.

Please hold down the button until the backrest is fully

reclined.

The controller becomes warm.

If the unit is used continuously for an extended

period of time it will naturally become warm.

If the controller becomes too hot, immediately stop

using the unit and return it for inspection or repair to

the place that you bought it.

The unit will not operate at all.

• Upper body (neck to lower back) massage.

• Leg massage.

• The power cord has been disconnected.

(See Page 11)

• The power switch on the unit has not been turned on.

(See Page 11)

• After pressing button, the program button or the

manual operation selection button has not been

pushed. (See Pages 14–17)

The power cord has been disconnected.

The unit has been damaged.

Unplug AC cord from outlet immediately and have

massage lounger serviced.

The power cord or power plug is abnormally

hot.

Unplug AC cord from outlet immediately and have

massage lounger serviced.

The length of the programs selected in

programmed operation varies.

• When using the massage lounger in programmed

operation, when the program is finished movement

automatically stops. (Although programmed

operation lasts for approximately 15 minutes

(12–17 minutes), this will vary according to the

shoulder position and program selected, whether or

not tapping is on or off, and the weight of the

person using the unit.)

It is not possible to recline the unit.

The legrest cannot be raised or lowered.

If the unit encounters an obstacle or if excessive

force is exerted on it during operation, in the

interests of safety the unit will come to a stop.

If all markings and buttons on the controller start to

flash, which is extremely unusual, turn off the power

switch, wait for approximately 10 seconds and then

turn the power switch on again.

Problem Cause and Remedy

Motor Noises

• The motor gets louder when it comes under load.

• There is excessive noise during Tapping.

(The noise is louder at the top of the unit.)

• The motor sounds louder when adjusting massage

intensity and width.

• There is a rubbing sound produced by the massage

heads rubbing on the seat fabric.

• There is a rubbing sound produced by fabric rubbing

on fabric.

TROUBLESHOOTING

These sounds are perfectly normal and will not have

any effect on the operation of the unit.

The massage heads stop during operation.

When the massage heads are raised or lowered, if

they come into contact with a wall or other obstruction,

in the interests of safety the massage heads may

stop moving. In such a situation, move the chair or

remove the obstruction and start the massage again.

If all markings and buttons on the controller start to

flash, which is extremely unusual, turn off the power

switch, wait for approximately 10 seconds and then

turn the power switch on again.

If excessive force is applied to the massage heads

during operation, in the interests of safety the

massage heads may stop moving. If this occurs,

raise your body slightly before restarting it.

If all markings and buttons on the controller start to

flash, which is extremely unusual, turn off the power

switch, wait for approximately 10 seconds and then

turn the power switch on again.

Nothing can be felt when using Tap A, Tap B

or Vibration.

If the massage heads are not touching your body

then you will, of course, feel nothing. Therefore,

please make sure that your body comes into close

contact with the massage heads.

The massage heads do not come up to the

shoulder or neck.

The position of the shoulders is incorrect.

(See Page 14)

Before requesting service for this unit, check the table below for the possible cause of the problem. Some simple

checks or minor adjustment on your part may eliminate the problem and restore proper operation. If you are in

doubt about some of the check points, or if the remedies indicated in the chart do not solve the problem, call us at

1-800-338-0552 to locate the servicer near to you.

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 55 56

Commentaires sur ces manuels

Pas de commentaire

Panasonic EP1060 Manuel d'utilisateur Page 27

Commentaires sur ces manuels

Produits connexes et manuels pour Meubles Panasonic EP1060