Panasonic WV-SF538 Guide d'installation télécharger pdf (Page 31)

Vertical position (Tilting)

Loosen the tilting lock screws (x2), and rotate

the tilting table to adjust the tilting direction.

(Adjustable range: ±75 °) Since a variable focal

lens is used, it is possible to change the angu-

lar field of view. This lens can also be rotated in

the reverse direction, but the image azimuth is

reversed. In this case, the image azimuth can

be modified when the panning table is rotated

to the direction of clockwise panning (180 °).

Horizontal: 24.20° (TELE) to 86.60° (WIDE)

After adjustment, tighten the tilting lock screws (x2) to fix the tilting table.

(Recommended tightening torque: 0.59 N·m {0.44 lbf·ft})

Note:

• When the tilting table is turned to the edge of the adjustable range (±75 °), it must be noted

that the shadow of the dome cover may be projected.

• When the camera is installed to a wall, the image is turned upside down in the default settings.

The way the image is displayed can be corrected in two ways: rotating the panning table 180°

clockwise, or selecting "On" for "Upside-down" from the setup menu. For information about

performing the "Upside-down" setting from the setup menu, refer to the Operating Instructions

(included in the CD-ROM).

Image tilt adjustment

Rotate the azimuth adjustment ring to adjust the azimuth angle of the image.

(Adjustable range: ±100 °)

+75 °

–75 °

Adjustable range

Tilting lock

screws (x2)

–100 °

+100 °

Adjustable range

Azimuth adjustment ring

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 47 48

Pas de commentaire

Panasonic WV-SF538 Guide d'installation Page 31