Panasonic KV-S1025C Guide d'installation télécharger pdf (Page 12)

Setting up the Scanner

 Power turn-on sequence

Turn on the power of the scanner.

• Connect the power cord to the AC adaptor.

• Connect the AC adaptor to the scanner.

• Plug into an AC outlet.

• Push the power switch.

• The LED (Green) will blink for about 30

seconds and then it will become steady.

Note:

• Install the software first.

 About LED

The status of the scanner can be established by the condition of the two LED indicators shown in the table below:

The scanning lamp(s) periodically lights up in sleep mode. This is not an unusual event.

For details on sleep mode, refer to the User Utility Reference Manual.

It will take about 30 seconds to initialize the scanner.

LED (Green)LED (Red)Status

ON OFF Ready

Blink (Slow) OFF Sleep

ON Blink (Slow) Warning

Blink (Slow) Blink (Slow) Warning/Sleep

ON ON Error

Blink (Fast) OFF Warming up

AC adaptor

Power cord

Power switch ( )

USB cable

Ready

Error

Start / Stop

LED (Green)

LED (Red)

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 45 46

Pas de commentaire

Panasonic KV-S1025C Guide d'installation Page 12