
The cursor does
not move from
trackball opera
tions
• Confirm that the device driver for the mouse works.
Please refer to the reference manual of the device.
• Try setting the [Track Ball] to enable in the Setup Utility.
• Has the Setup Utility been used to set [Serial Port] to [2F8]
or [3F8]?
The device con
nected to the se
rial port does not
work
• Check the connection.
• Confirm that the device driver for the serial port works. Please
refer to the reference manual for the device.
• Confirm that two mouse devices are not connected, one
through the ext. keyboard/mouse port and the other through
the serial port.
• Try setting the [Track Ball] to disable in the Setup Utility.
A PC Card does
not work
• Make sure the card is properly inserted.
• Confirm that the card conforms to the PC Card Standard.
• A driver for Windows 95 may need to be installed.
• Note that after a driver is installed, the computer must be
rebooted.
• Check that the proper port settings have been made.
• Read the PC Card’s manual. Or, you may need to call the
source of the PC Card.
• When using a CardBus type card, no other types of cards can
be used.
• Some ZV Cards may not work if installed in slot 2.
You do not know
the available
RAM module
O page 46
Tbe RAM module
has not been rec
ognized
Make sure the RAM module has been properly inserted.
The address map
for IRQ, I/O
port address, etc.
is unclear
Click [Start] - [Settings] - [Control Panel]. Double-click [Sy.s-
tem]. Check the address map by going to [View Resources] in
[Device Manager] - [Computer) - [Properties].
A USB device
does not work
• Has the Setup Utility been used to set [USB Port] to [En
abled]?
• Make sure a driver is installed.
• Contact the manufacturer of the product.
57
Commentaires sur ces manuels