Panasonic PT-LB2U Instructions d'exploitation Page 12

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 66
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 11
Preparation
12
ENGLISH
Details of your projector (continued)
Terminals
Remote control signal receptor
AC IN
Connect the power cord to supply electric power to
the projector. (
page 18)
Air intake port
Front leg adjuster
To adjust the projection angle. (
page 22)
Rear leg adjuster
To adjust the projection angle. (
page 22)
Burglar hook port
Attach a commercial burglar prevention cable.
Air outlet port
Hot air comes out from this opening.
Speaker
Lamp unit compartment (
page 46)
Connect to a network cable.
(See “Network Operation Manual”.)
Connect to a computer to control the projector’s
operation.
(
page 17, 51)
Connect to a computer or YP
B
P
R
signal cable.
(
page 17)
Connect to an S-VIDEO signal cable.
(
page 16)
Connect to a VIDEO signal cable.
(
page 16)
Connect audio cables for inputting audio signal.
(
page 17)
Connect an audio cable for audio signal output
to the connected equipment. If it is connected to
this terminal, no sound comes out of the built-in
speaker.
(
page 16, 17)
NOTE:
Do not place your hands or other objects close to the air outlet port as this may cause damage or injury.
Do not place your hands or face, or objects which cannot withstand heat near the air outlet port. Hot air comes out
from this port.
Rear and bottom view
Terminals
LAN
SERIAL
COMPUTER 1 IN
S-VIDEO
IN
VIDEO IN
AUDIO IN
1 2
AUDIO
OUT
COMPUTER 2 IN
NOTE:
Do not connect any power cable other than the attached one.
Do not cover the ventilation openings of the air intake port or air outlet port.
Vue de la page 11
1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 65 66

Commentaires sur ces manuels

Pas de commentaire