Panasonic AJ-D910WBP Manuel d'utilisateur Page 18
- Page / 160
- Table des matières
- MARQUE LIVRES
Noté. / 5. Basé sur avis des utilisateurs
–18–
Controls and Their Functions
Shooting (Recording)/Playback Function Section (4)
· VTR START button
When this pressed, recording commences; when it is pressed again, recording stops. This
button has the same function as the VTR button on the lens side.
¸ VTR SAVE/STBY (tape protection) switch
This selects the power supply status while the VTR recording is temporarily stopped (REC
PAUSE).
SAVE: This is the tape protection mode. The cylinder is stopped in the half-loading status.
Compared with the STBY position, less power is consumed and the unit can be
operated longer using the battery. It takes longer for recording to commence after
the VTR START button · is pressed in the SAVE position than in the STBY po-
sition.
When the switch is set to this position, the VTR SAVE lamp inside the viewfinder
lights.
STBY: Recording commences immediately when the VTR START button is pressed.
|Note{
This unit will automatically go into SAVE mode when the designated time for standby (STBY)
condition is exceeded. To return to standby mode, press the VTR SAVE/STBY switch once to
select SAVE mode, then once again to return to STBY mode.
¹ MODE CHECK button
While this button is kept depressed, the camera’s setting status is displayed in the viewfinder. It
does not affect the camera’s output signals.
º SUPER GAIN button (inside sliding cover)
The super gain mode is forcibly established when this button is pressed, and each time the
button is pressed when all the super gain values have been set using “SUPER GAIN” on the
MAIN menu 2 of 4 screen, the gain is switched by one level in the following sequence: 30 dB>
36 dB>43 dB>46 dB>OFF>30 dB, etc. However, the DTL and other menu settings cannot
be performed.
» SUPER IRIS button (inside sliding cover)
This is used when backlight compensation (or the super black functionF
1
) is to be provided.
When it is pressed, the switch settings are displayed inside the viewfinder for 3 seconds. When
it is pressed again, backlight compensation (or the super black functionF
1
) is released.
F
1
See Main Menu Screen 2 of 4 on page 126 for details on the super black function.
Super gain: When 30 dB is allotted to the SUPER IRIS button, DTL and other menu settings cannot be performed for this
30 dB.
∑
º
π
∫
∏
ª
- Operating Instructions 1
- For your safety 2
- Contents 3
- General and Features 5
- Features 6
- System Configuration 9
- Controls and Their Functions 10
- Power Supply 23
- 1 Mount the battery pack 23
- 1 Detach the battery mounts 24
- 1 Remove the battery mounts 26
- Battery clamp 27
- To check the type of battery 29
- To select the type of battery 29
- Lens Clamping Lever 30
- Mount Cap 30
- LENS Connector 30
- Adjustment method 31
- Adjusting the Flange Back 31
- WHITE BAL: A or B 33
- SHIFT/ITEM 33
- Adjusting the Viewfinder 34
- Adjusting the diopter 35
- Adjusting the screen 35
- 1 Press the lock button 36
- 3 Detach the eyepiece 36
- Mounting the Viewfinder 37
- Detaching the Viewfinder 37
- Audio Input Preparations 38
- 2 Mount the microphone 38
- Mount the microphone 39
- To the MIC IN Connector 39
- Mounting the Unit to a Tripod 42
- Mounting the Shoulder Belt 43
- 1 Loosen the two screws 44
- Attaching the Rain Cover 45
- 6-pin Cable 46
- ECU Connector 46
- Setting Menu Configuration 47
- Press the PAGE button 50
- DIAGNOSTIC screen settings 50
- SHIFT/ITEM Switch 52
- UP Button 52
- DOWN Button 52
- PAGE Button 52
- MENU SET/OFF Switch 52
- To select a MAIN menu page 53
- Selecting the desired item 54
- Changing the settings 54
- Changing the ON/OFF selection 54
- Quitting the menu 54
- VTR SAVE 55
- -40 -30 -25 -20 -15 -10 -5 0 59
- Selecting Display Items 60
- ¿: Message displayed 61
- Changing the Display Mode 62
- Setting the Marker Displays 62
- SHIFT/ITEM button 63
- UP and DOWN buttons 63
- E TAPE F 64
- E BATT F 64
- Time Code-Related Displays 65
- TIME/DATE 66
- Selecting Functions 69
- Adjusting the White Balance 70
- Adjusting the Black Balance 75
- Shutter Modes 77
- SHUTTER Switch 78
- SYNCHRO SCAN Mode 78
- Standard Mode 78
- SUPER V Mode 78
- SYNCHRO SCAN 79
- Adjusting the Audio Level 82
- Setting the Time Code 83
- Setting the User Bit 84
- MASTER SLAVE SLAVE 85
- Setting the Time Data 86
- Using the user data 86
- Setup Card Operations 87
- Writing set data to cards 90
- When data is not read out 92
- Cassettes 93
- Basic Procedures 95
- Recording 96
- Shooting images 97
- 1 Turn the power back on 98
- Rec Review 100
- Color Playback 100
- R signal 101
- B signal 101
- Connections 102
- Starting Recording 102
- RET Button 106
- Replacing the Backup Battery 107
- LOW SETTING screen 114
- MID SETTING screen 115
- HIGH SETTING screen 116
- KNEE/LEVEL screen 119
- VF DISPLAY screen 121
- VTR FUNCTION screen 128
- MIC/AUDIO screen 134
- USER MENU SEL 1 of 3 screen 138
- REMOTE menu screen 147
- Warning System 149
- Maintenance 152
- Inspection Preparations 153
- Inspecting the Camera Section 153
- Inspecting the Viewfinder 154
- Inspecting the VTR Section 155
- Specifications 157
Produits connexes et manuels pour Appareil photos Panasonic AJ-D910WBP
(120 pages)© 2020, manymanuals.fr. Tous droits réservés | 2.070 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels