Panasonic WV-ASC970 Instructions d'exploitation télécharger pdf (Page 11)

Note:

 • Toselectalocaltoursequence,justenterthelogicaltoursequencenumber.(Refertop.45.)

 • Thesystemsupportsupto256toursequencesrunning.

 • During3secondsdwelltimeincaseofWJ-GXD400,thevideoandOSDdisplaywilldelayaccordingtoswitch-

ing channel numbers.

■

Group Preset

● Local Monitor Seize and execute

The system allows operators to execute a group preset in only local domains. Before starting a group preset start, a

local monitor must be seized. Be sure that the group preset monitors are not seized by operators with higher priori-

ty.

■

Group Sequences

● Local Monitor Seize

The system allows operators to start and control a group sequence in only local domains. Before starting a group

sequence operation, a local monitor must be seized. Be sure that the group sequence monitors are not seized by

operators with higher priority.

● Group Sequence Operation

Group Sequence operations include start, stop, pause, run, next step, and previous step. (Refer to p. 45.)

● Group Sequence Priority

If another operator with higher priority has seized a Group Sequence monitor, that monitor will maintain the original

operator priority.

Note:

 • GroupSequencemonitorsshouldbethesameineachstepofsequenceandlessthan33.

 • During3secondsdwelltimeincaseofWJ-GXD400,thevideoandOSDdisplaywilldelayaccordingtoswitch-

ing channel numbers.

 • GroupSequenceisnotrestoredafterrebootorswitchover.

 • Whenanoperatorselectoneofrunninggroupsequencemonitorthatisseizedbyotheroperatorwithsamepri-

ority, the sequence keeps running.

When a operator seized one of running group sequence monitor that is not seized by the other operator with

same priority, the sequence stops.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 78 79

Pas de commentaire

Panasonic WV-ASC970 Instructions d'exploitation Page 11