Panasonic SCEN17 Manuel d'utilisateur télécharger pdf

Matsushita Electric Industrial Co., Ltd.

Web Site: http://www.panasonic.co.jp/global/

RQT7894-B

M1204SM0

Dear Customer

Thank you for purchasing this product.

Before connecting, operating or adjusting this product, please read these

instructions completely.

Please keep this manual for future reference.

These instructions are applicable to the following systems.

Display

System SC-EN17

Main unit SA-EN17

Speakers SB-EN17

Operating Instructions

CD Stereo System

Model No. SC-EN17

Troubleshooting guide

Before requesting service, make the following checks. If you are in doubt about any of the check points, or if the solutions indicated in the chart do not solve the problem,

consult your dealer for instructions.

No play.

• The disc isn’t correctly set.

• The disc is scratched or dirty. (Tracks skipped.)

• There is moisture on the lens. Wait for about an hour

and then try again.

MP3 cannot be read.

• You may not be able to play MP3 if you have copied a

multi-session disc that has no data between sessions.

• When creating a multi session disc, it is necessary to

close the session.

• The amount of data on the disc is too small. Set the

amount of data to greater than approximately 5 MB.

Sound is unfixed,

reversed or comes

from one speaker only.

• Check the speaker connections. (→ page 2)

No sound or there is a

lot of noise.

• Noise may occur when playing MP3 if recording quality

is poor.

• Keep this unit away from mobile telephones.

• Turn the volume up.

• Switch the unit off, determine and correct the cause,

then switch the unit on. Causes include shorting of the

positive and negative speaker wires, straining of the

speakers through excessive volume or power, and

using the unit in a hot environment.

Humming heard during

play.

• An AC mains lead or fluorescent light is near the cords.

Keep other appliances and cords away from this unit’s

cords.

A beat sound is heard

while receiving a radio

broadcast.

• Switch the TV off or separate it from the unit.

A low hum or noise is

heard during AM

broadcasts.

• Keep the antenna away from other cables and cords.

• Keep the AM antenna away from the unit.

The picture on the

television near the set

disappears or stripes

appear on the screen.

• The location and orientation of the antenna are

incorrect.

• The TV antenna wire is too close to the unit. Separate

the antenna wire of the TV set from the unit.

Remote control

doesn’t work.

• Check that the batteries are inserted correctly. (→ page

• Replace the batteries if they are worn.

– –:– –

• You plugged the AC mains lead in for the first time or

there was a power failure recently. Set the time. (→

page 5)

• The total programmed play time is more than 200

minutes.

Tracks can still be programmed and played.

PGM FULL

• The number of programmed tracks is limited to 24. No

further tracks can be programmed.

NOT MP3

• A CD-ROM disc that is not CD-DA or MP3 format is inserted.

It cannot be played.

ERROR

• Incorrect operation performed. Read the instructions

and try again.

F76 • There is a power supply problem. Consult the dealer.

GCS

Note

“EB”

on the packaging indicates the United Kingdom.

1 2 3 4 5 6 7 8

Résumé du contenu

Page 1 - Troubleshooting guide

1Matsushita Electric Industrial Co., Ltd.Web Site: http://www.panasonic.co.jp/global/RQT7894-BM1204SM0Dear CustomerThank you for purchasing this produ

Page 2 - The remote control

2Placement of speakersYou can remove the speaker cover.Note• Keep your speakers at least 10 mm away from the system for proper ventilation.• These spe

Page 3 - CD operations

3CD operationsLIGHTSLEEPCLOCK/TIMER ADJDISPLAYTIMERSET/CHECKPGM/CLEAR-AUTO PRESET OPEN/CLOSE1234567809>=10AUXTUNER/BANDCDEXTRAD.BASS SOUNDEQLIVEVIR

Page 4 - Radio operations

4Radio stations can be tuned manually by selecting the station’s frequency or they can be preset into channels to make it easy to tune.You can preset

Page 5 - Timers and others

5Timers and othersLIGHTSLEEPCLOCK/TIMER ADJDISPLAYTIMERSET/CHECKPGM/CLEAR-AUTO PRESET OPEN/CLOSE1234567809>=10AUXTUNER/BANDCDEXTRAD.BASS SOUNDEQLIV

Page 6 - Control guide

6Standby/on switch [^, ^/l]... 3Press to switch the unit from on to standby mode or

Page 7 - LASER PRODUCT

7Set the unit up on an even surface away from direct sunlight, hightemperatures, high humidity, and excessive vibration. These conditions candamage th

Page 8 - Specifications

8(For continental Europe and the United Kingdom)(For other areas)SUOMINORSKTo clean this unit, wipe with a soft, dry cloth.• Never use alcohol, paint